Wins 10

0.7.1 hotfix

I was testing Neigborhood cycling to try and encounter the Black screen> I could not do that but encountered the following:

1) "The box that appears after cycling for you to confirm or reject remains in place once I have chosen to confirm and the Node has actually cycled. When you confirm a second time, it cycles but to the same descriptors again and then the box disappears" This is the breadbin screenshot. It is quite rare and hard to reproduce.

2) When choosing to cycle, the 2 entry descriptors were identical as you can see on the screen shot and it allowed me to proceed by clicking "Save and restart Node". The other screenshot shows the failure to connect following the above. I should not have been allowed to select "Save and restart Node" due to the duplicate descriptors. Did this then cause the failure to connect and the break in the logic allowing step 3 to keep trying while step 4 had failed?

It crashed and I could not shut down the modal with the X.

This may be 2 separate cards?